<noscript id="aekai"><wbr id="aekai"></wbr></noscript>
<center id="aekai"><wbr id="aekai"></wbr></center><noscript id="aekai"></noscript>
<center id="aekai"></center><center id="aekai"><div id="aekai"></div></center>
<noscript id="aekai"><wbr id="aekai"></wbr></noscript>
<center id="aekai"><wbr id="aekai"></wbr></center><optgroup id="aekai"></optgroup>
<center id="aekai"><wbr id="aekai"></wbr></center>
<center id="aekai"></center><center id="aekai"><div id="aekai"></div></center>

Slick Pipe(Joint)

WP :

 10K/15K

Material :

 Alloy steel

Standard :

 NACE MR0175

For more infos, please contact us by email.

Product introduction:

Slick Pipe(joint)/Sliding Pipe(joint) is located below the SSTT-subsea test tree and is designed specifically to allow a blowout preventer’s pipe ram to close and seal around the outside diameter. This seal is used to isolate the annulus from the marine riser.The slick joint is available ported with a single 1/3 inch or 1/4 inch port that is carried through from the subsea test tree, which allows the operator the ability to pump chemical or control fluids to a sub situated down hole. Dual check valves isolate porting from wellbore pressure.








?
亚洲Av欧美日韩Av在线